| Widescreen Gaming Forum http://www.wsgf.org/phpBB3/ |
|
| Matrox Setup Wizard Error... http://www.wsgf.org/phpBB3/viewtopic.php?f=67&t=18425 |
Page 1 of 1 |
| Author: | acerocksWS [ 20 Nov 2009, 21:57 ] |
| Post subject: | Matrox Setup Wizard Error... |
While using the Matrox setup wizard I chosse: Display Setup: TripleHead [X] Install triple wide-screen modes [NEXT] (O) Manually select modes (O) Wide-screen modes [1680x1050 per monitor (output refresh rate ;55Hz)] [NEXT] [NEXT] It applies settings ok for: Installing INF files Updating graphics hardware settings Installing additional modes Installing selected display setup Saving wizard information But I get red X's on: Applying mode The message beside the red X is: {A Windows error has occurred} My equipment is: eVGA x58 w i965 12GB DDR3 (3) eVGA GTX280's in TRI-SLI mode (currently 3840x1024) nVidia Driver v191.07 Matrox Triple Head2Go Dig Ed. (3) 24" Widescreen monitors that natively suuport 1920x1200 @ 60MHz Vista 64 Bit Ultimate SP1 w/All patches I am using Firmware vxp2k_THDE_v2.3.40.t6.56.exe Any ideas so that I can get the 5040 x 1050 max resolution? Thanks for any help you can offer! |
|
| Author: | mero [ 22 Nov 2009, 13:42 ] |
| Post subject: | Matrox Setup Wizard Error... |
[1680x1050 per monitor (output refresh rate ;55Hz)] Try here to set 1440x900 per monitor under the triple wide modes. and after reboot you can choose 1680x1050x3@59Hz. I installed the 195.55 NV-driver and it works (for me) Tobi |
|
| Page 1 of 1 | All times are UTC [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|