Widescreen Gaming Forum

Is it possible to get SF V working with an ultra wide? I saw today a simple fix for Tekken 7 was put out to remove the black bars. Is that possible for SF V?

bump please

Thanks, but this doesn't seem to work for me. I followed your tutorial but when I press F1 nothing happens. I also see an FOV option as well. Is this cheat table supposed to also do a FOV fix? Perhaps this only works with an older version of the game?

The only problem I ran into with your tutorial is when I load the cheat table I don't get this prompt " "This table contain a lua script. Do you want to run it?" The table just loads but says nothing. Idk if this is helpful for trouble shooting.

What values did you have in table at step №7 ?
Black_Bars should be "01" and FOV should be "0.002777777845"

Check settings in CE:
Edit - Settings - General Settings - Ask to run lua script from table

You can manipulate FOV using this table.

I test it on Ver.02.021

I did go into settings and ask to run lua script was not checked off. I did, but it still doesn't work.

When you say values in the table, do you mean at the bottom where it says Active, Description, Address, Type, Value? For black bars the value down there is 00. For FOV the value is .003467142349. So if that's what you mean, then it's not right. I also try to change the values but whenever I tab back into the game it changes them back to "00", and ".00346...." Any ideas what I could be doing wrong now? Thanks.

This looks interesting. I know that the Tekken fix works (I play it) but how will it work with Street Fighter? Street fighter has a fixed camera, that means if you get far from your opponent, you can't go further than the actual 'screen edge'. Being 21:9 wider than 16:9, is there an invisible wall that stops you from going to the edge of the visible stage (on the 21:9 screen) ?

So basically on the 21:9 screen you can't walk past the invisible walls placed on the lines of the 'virtual' 16:9 screen?

Thanks man! It's almost perfect Once the game loads up it is in 21:9 automatically. I didn't have to press F1 or anything. The problem is it's zoomed in a bit too much. I like how the characters are bigger and easier to see but their feet are cut off. Is there any way to fix that? Thanks again for your help.

You can't pass invisible line that limited to 16:9.


Try this table: