Widescreen Gaming Forum

Hello, Skip!

Thank you for your very quick response. I made an error, it should have been two 34" inch LG ultrawide. After reading your response, it should be okay unless you have had issues with that setup before. I already have a DXracer so that is taken care of. Again, I appreciate your response.

Two 34" is fine. We've had plenty of people do those. You'll need an HD pivot for each 34" panel. I'm out of stock on those at the moment, but have more on the way from Ergotech.

Good deal! Thank you again!

I was looking at getting the WSGF Ultimate Desk Stand v2 and the HD pivot for a ultra wide on top and I was just wondering if I decided to move the ultra wide to the middle of the lower row could 2x27'' be used in portrait mode on either side of it, not for gaming just as extra screen space?

Thanks

I've not tried that specifically, but it should work. I did do a 34" with 25" flanking in portrait. There was plenty of room left on the bar for 27" panels. You can see the pic at the bottom of this page:

http://www.wsgf.org/article/review-lg-3 ... lay-page-2

Ok, thanks. If I plan getting an ultra wide for either the middle or the +1 in a 3+1 config I will an HD pivot for the position I place it in correct? Also, are screws included, if not what screw should one be using?

Yes, you will need an HD pivot for any 34" panel. And screws are included.

Hey there,
I'm about ready to pull the trigger on this Ultimate Desk Stand v2, but I have a problem. I intend to use it in the beginning (until I upgrade my monitors) with 3 x 27" 16:9 monitors... the issue is that they are VESA MIS-E! So that's 200x100 6 hole mounting pattern. Is there a conversion plate or something that I could add to allow use with this stand? Eventually I'll end up with newer, standard pattern monitors, but for now... I'm wondering if anyone else has used this bolt pattern with this stand setup?

Thanks.

You'll need an adapter. Amazon has several for sale. Newegg has a couple as well. Just search for "VESA 100 200".

Awesome, I'll take a look... Thanks!!